well on 095 all worked fine, but when i tryed to convert to pol 096, this happens:

in this house:
http://www.riklemmers.nl/neverlands/info_houses/10
you cant go into the small room where the stair is in the first flood - what could it be? and how do i fix it? thanks

You will have to put the ladder 1z down (or was it up?) inside these multis.
Also possible is that some floor tile on the first floor is blocking you from walking upstairs. That's hard to see on this picture.

you cant walk in the WHOLE room, not just up the stairs - its like theres a wall there

i cant go past the red line

I asume that this is a multi?
If so, do you have a .wsc file or something else like that of that single multi or can you give a link to the multi.mul/idx which contains that building? Then i test it on our shard.

http://www.ideazione.com/neverlands/dow ... nstall.exe

thanks a ton dude

thats the whole install pack btw, dont have a host so i can get only the multi.mul online :'(

or even better
http://www.freewebs.com/deividson/multi.idx
http://www.freewebs.com/deividson/multi.mul

On the first floor i can walk without problems.
On the ground floor i also can't walk into or in that room.
This is because there are a lot of invisible slate roofs (Objtype: 0x59f = 1439) filling the whole room